Sell capacitor

The factory can supply capacitor, the detail specification as below :
General Description
SENTAI brand of self - healing type low voltage shunt capacitor made of the advanced metallized film, is produced strictly in accordance with the National standard and IEC Standard by the introduced advanced foreign techniques and equipment. The device is mainly suitable for low voltage electric network to improve power factor, reduce reactive loss and better the voltage quality.
The company depends on the superiority of science and technology and manages strictly in compliance with ISO9002, so the quality of the products is excellent but there are competitive and our servies are all - round.
Main Features
1. Compacted and light : Its volume and weight are only 1 / 4 and 1 / 5 of the old product because of the using of a new dielectric - mtallized polypropylene film.
2. Low loss : The real figure is lower than 0.10%, so the loss of the capacitor itself is extremely low, the heat it gives out is little and the rise of temperature is low. So its service life is very long and it can save energy at the same time.
3. Excellent self - healing ability : Damage of part of the dielectric caused by over - voltage can be self - healed quickly and return to normal state. So the reliability is much higher.
4. Safety :Inwardly eaquipped self - discharge resistor and safety equipment. The self - discharge risistor can automatically discharge the electric energy the capacitor carried. If there is anything fault with the capacitor, thus prevent further troubles from happening. So it's much safer to use this kind of capacitor.
5. No oil leakage : The capacitor uses advanced semi - soild impregnant whose drip melting point is above 70. There will be no loss of oil during the course of using it. And thus protect the surroundings from being polluted. The capacitor itself doesn't have to run the risk of invalidation caused by oil leakage.
Main Technical Charateriatics
1. Sevice conditiond : ambient temperature - 25 + 50, humidity 85% RH, and altitude lower than 2000m.
2. Rated voltage : 250VAC, 400VAC, 525VAC, 750VAC, 1050VAC
3. Rated output : 1~ 100kvar.
4. Capacitance tolerance :0 +10%.
5. Tandent of the loss angle :With the power frequency rated voltage, tg0.
6. Withstand of voltage : Between terminals 1.75 times rated voltage for 10 seconds, between terminals and container 3kVAC for 10 seconds.
7. Max permissible over - ovltage : 110% rated voltage.
8. Max permissible over - current : 130% rated current.
9. Self sustained discharge ability : Give Un DC voltage to capacitor, the residual voltage reduced to 50 V or lower within 3 minutes afte power off.
10. Applicable standard : GB 12747 - 91 / IEC60831 - 1988